Home    LED Open Plafonds  Handleiding & Technische Specisficaties
Handleiding & Technische Specisficaties

Handleiding & Technische Specisficaties


Technical Requirements and Installation Manual
Can the OpenCeiling be installed in your false/suspended ceiling?
Below is a simple 3-step checklist


Klik hier voor technische informatie

Artikelcode: Install

Handleiding & Technische Specisficaties


  • Productinformatie



Technical Requirements and Installation Manual

Do the ceiling panels measure 60cm x 60cm or 120cm x 60cm (US ceiling sizes: 2ft x 2ft or 4ft x 2ft)?
120cm x 60cm grids should be divided into 2 sections of 60cm x 60cm by installing a 60cm (2ft) grid connector.
Does the width of the grid measure 24mm (15/16”)?




2 .Is the clearance between the base of the false ceiling grid and the structural ceiling 7,5cm (3”)?

(Please note that in cases with less clearance installation could still be possible, please contact OpenCeilings)

There must be no obstacles in the clearance area

(i.e pipes or vents) to be able to install the OpenCeilings LIGHTÒµXTURE


Replace hook hangers with wire

In some instances, false ceilings are installed using ‘ceiling hangers’. These hangers might interfere with the installation of the OpenFrame. In order to ensure a seamless installation of the OpenFrame, PLEASE  REPLACE THE ÒµXEDÒ ceiling hangers for strong iron wire in the area where the OpenCeiling is installed.

Always ensure that your false ceiling can maintain the weight of the OpenCeiling. If necessary, please reinforce your false ceiling with ceiling hangers or strong iron wire!!



Installation manual

1. Daylight-balanced (6000K) LED panel with LED Driver
2. High resolution photopanel

3. Frame which supports both photopanel and LED panel

Fits seamlessley in every 60cm x 60cm false ceiling grid.

Plug and Play model LED OpenCeiling

5-step installation instructions:

1.     Make sure that your ceiling complies to the 3 points indicated in the checklist (previous page)

2.     Remove the ceiling panels for the area where you want to install the OpenCeiling

3.     Insert the complete Plug and Play model diagonally through the ceiling grid. Carefully place the Plug and Play model onto the grid. Make sure that the orientation of the image corresponds with the provided image-layout

4.     Connect the OpenCeilings Plug and Play model to a power point with the provided LED driver

5.     Repeat step 3 and 4 according to the image-layout.

Always ensure that your false ceiling can maintain the weight of the OpenCeiling. If necessary, please reinforce your false ceiling with ceiling hangers or strong iron wire!!